Nutone 9960 Uživatelský manuál stáhnout pdf

INSTALLATION INSTRUCTIONS

READ & SAVE THESE INSTRUCTIONS!

Heat-Light

Combination

(with Night Light)

MODEL: 9960

FOR BEST RESULTS

In a new construction site, install the housing (complete

with heater) during rough-in construction of the building. The

light assembly and the grille should be installed when the

finished ceiling is in place.

Installation in an existing, finished building requires an

accessible area (attic or crawl space) above the planned

location. See “INSTALLATION IN EXISTING

CONSTRUCTION.”

Do not install closer than 12 inches to a vertical surface.

Do not install over tub or shower enclosure.

UNIT DIMENSIONS

Refer to Figure 1 for housing's dimensions.

NOTE: If there will be a finished second floor above,

the Model 9960 housing requires a minimum of 2" x 8"

joist construction for mounting.

WIRING AND DUCTWORK

1. Run the required wiring during rough-in stage of

construction.

2. Total connected load: 1680 watts.

3. Plan to run 120vAC, 60 Hz wiring (with ground) on a

separate 20 Amp circuit from a power source, through

the provided wall switch, to the housing’s junction box.

See wiring diagram.

INSTALLATION IN

NEW CONSTRUCTION

PREPARATION

1. Loosen hanger bar brackets to allow bars to be inserted.

2. Refer to Figure 2. Insert hanger bars into brackets.

3. Refer to Figure 3. Slide hanger bar brackets down to end

of slot closest to outside edge of housing. Tighten brackets

in this position.

4. Refer to Figure 4. Remove junction box cover by

removing one screw.

5. Refer to Figure 4. Remove appropriate wiring knockout(s)

and install approved box connector(s).

FIGURE 1

FIGURE 2

FIGURE 3 FIGURE 4

⁄

14"

HANGER BARS

ADJUSTMENT

SLOT

JUNCTION

BOX

COVER

KNOCKOUTS

⁄

1 2 3 4

Shrnutí obsahu

Strany 1 - Combination

INSTALLATION INSTRUCTIONSREAD & SAVE THESE INSTRUCTIONS!Heat-LightCombination(with Night Light)MODEL: 9960FOR BEST RESULTSIn a new construction si

Strany 2 - MOUNTING THE GRILLE ASSEMBLY

MOUNTING THE HOUSING1. Locate housing between joists.2. Refer to Figure 5. Using nails, secure hanger bars to joist.NOTE: The hanger bar brackets are

Strany 3 - EXISTING CONSTRUCTION

INSTALLATION INEXISTING CONSTRUCTIONIn an existing, finished building, installation of the Heat-Light Combination requires an accessible area (attic o

Strany 4 - One Year Limited Warranty

Product specifications subject to change without notice.Printed in U.S.A., Rev, 5/2001, Part No. 89350One Year Limited WarrantyWARRANTY OWNER: NuTone

Komentáře k této Příručce

Žádné komentáře

Nutone 9960 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Čerpadla Nutone 9960. NuTone 9960 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce